Product -> GMS/FMA

FMA 3004
"PE Foam Stabilizer"
Application: Fine foam cell structure stabilization of PE foam sheets.
Active Ingredients: Proprietary compound.
Carrier: LDPE
Active Content:: 30 wt.%
Alpha-monoglyceride 10.5
Physical Form: Off-white opaque solid pellets.
 
Technical Data:
Melting Point Greater than 100° C.
Processing: 150° to 210° C.
 
Recommended Processing Condition:
Foam Extrusion

1. Fine cell structure stabilization of extruded foam PE using Azo and/or physical blowing agents.

2. Improved adhesion and moisture resistance at the outer surface of the foam.

 Use level is 5 to 8 wt.% depending on the application.
 
Benefits:
  • Consistent and constant feed as evidenced by no change in screw amps.
  • Extended shelf life of FMA 3004 as it is encapsulated with a hydrophobic proprietary additive.
  • Higher foam cell count per unit volume.
  • Smooth surface of the final foam article.
  • Controlled diffusion rate of the physical blowing agent.
  • Improved physical properties. (e.g low shrinkage, improved compression strength).
 


The above information is offered as true and accurate to the best of our knowledge. This company makes no guarantee of results and assumes no obligation or liability in connection with the same.


"from Concept to Completion...."