| Product ->PolyFoam |
PolyFoam 7004F "Chemical Blowing Agent & Nucleating Agent" |
| Application: Foaming of thermoplastics on injection molding and sheet extrusion . Microcellular foam cell structure. |
| Active Ingredients: Proprietary multiconponent endothermic system. |
| Carrier: PE wax |
| Active Content: 70 wt. % |
| Physiology: The raw materials used comply with USFDA . |
| Physical Form: White pellets. |
Technical Data: |
| Decomposition Initial: Approximately 160 ° C. |
| Processing: 200° to 230° C to achieve optimum gas yields. |
Recommended Processing Condition:
|
| Injection molding: Removal of sink marks 0.2 to 0.5 wt% |
| Weight reduction of the molded part - based on the geometry. 0.5 to 2.5 wt % |
| Sheet Extrusion: Nucleation in conjunction with environmentally friendly gasses. 0.2 to 0.5 wt. % |
| Chemical foaming 0.5 to 1.5 wt% |
The above information is offered as true and accurate to the best of our knowledge. This company makes no guarantee of results and assumes no obligation or liability in connection with the same.
|
